A Wooden Vessel That Does It All
Dive — Cruise — Fish

26 feet. Very Seaworthy. Great on Gas. Ample Deck and Storage Space. Well Kept.

$9999: boat, trailer, eqpt, etc.

The boat is a 1977 Clipper Craft, made in Portland, Oregon. It’s constructed of teak and mahogany. 26 feet long, beam 8 feet at the gunnel. Power is a Volvo 140 with a 280 outdrive, raw water cooled with a heat exchanger. The boat has two poly 18-gallon fuel tanks, with capacity gauges for each tank. There are 372 hours on the engine since complete overhaul-rebuild that I did and it has been outfitted with a cast bronze exhaust manifold. There is a 1⁄4-inch thick x 1.5-inch strip of stainless steel on the keel.

Equipment on the boat includes:
---two fire extinguishers
---GPS
---VHF radio
---fathometer
---spare propeller
---radar reflector
---two inflated rubber bumpers
---single 12-volt battery
---two anchors
---two bilge pumps
---custom-made ladder for diver retrieval
---DAN 2-cylinder oxygen supply system

There is a porta potty in the cuddy cabin. There are also approximately a dozen Coast Guard approved adult life vests on board as well as the required signal flares. The boat has 4 removable custom-made stainless steel rod holders for fishing.  Numerous mechanical and electrical spare parts are maintained on board for underway emergencies. The battery is maintained on a trickle charger when not installed in the vessel. The trailer is a ROAD RUNNER , purchased new about 5 years ago (galvanized) with a hand-operated winch, electrical brakes and built-in flush system for the brakes.

Contact:
Ron Renner
Vancouver, WA
360-606-2949
my83hd@comcast.net